Settings - Husqvarna RC 455 Bedienungsanweisung

Menu functions

Settings

All Setting options for the hydraulic unit and the remote
control are accessed via this sub-menu.
A four digit code must be entered to access the settings
sub-menu. This code is 0012.
The code is stated one digit at a time, from left to the right.
The arrow keys scroll from 0-9 and the OK button confirms.
The "SETTINGS" menu consists of seven sub-menus,
which in turn consist of a number of part menus:
1. Select language
2. Adjust the hydraulic valve for the blade
3. Adjust the hydraulic valve for the feed
4. Sensor on/off calibrate
5. Hydraulic unit settings
6. Basic setting
7. Out settings
The numbers refer to the following headings.
1. Select language
Using this sub-menu you can set the language you
wish to use on the display.
The sub-menu always has the heading in English. The
selected language is stated under heading.
To select the language:
• Scroll using the arrow keys until the required language
is shown.
• Press OK.
• Press the down arrow to continue to the next sub-
menu.
2. Adjust the hydraulic valve for the blade
This sub-menu contains setting options for the rotation
of the blade and consists of three part menus:
Change the start point for the blade
Change the end point for the blade
Change the ramp time for the blade
2.1. Change the start point for the blade
The start point value should be adjusted so that the
blade rotation is as low as possible when the blade
rotation knob is turned from its left-hand position.
A too low value results in the need to turn the knob
before the blade starts to rotate.
A too high value results in the blade rotating too quickly
when the knob is turned.
18 - English
2.2 Change the end point for the blade
The end point value should be adjusted so that the
blade rotation is as high as possible when the blade
rotation knob is turned to the right.
A too low value results in full power from the hydraulic
unit never being reached.
State the end point value:
• Press OK when the part menu is shown.
The display shows: CHANGE END POINT and a
percentage value.
Scroll using the arrow keys to state the required end
point. Hold the arrow key held down to increase the
scrolling speed. The scale is graduated from 1-100 %.
• Press OK.
• Press the down arrow to continue to the next part
menu.
2.3 Change the ramp time for the blade
The ramp time value states how fast the blade's speed
of rotation shall change when the blade rotation knob is
turned.
A too low value means the blade motor's hydraulic
system will start to self-oscillation.
State the ramp time value:
• Press OK when the part menu is shown.
The display shows: CHANGE RAMP TIME and the
time in seconds.
• Scroll using the arrow keys to state the required ramp
time. Hold the arrow key held down to increase the
scrolling speed. The scale is graduated from 0.0 to
9.9 seconds.
• Press OK.
• Press the down arrow to continue to "Back to the
menu".
This sub-menu contains setting options for blade feed,
both horizontally and depth.
The sub-menu consists of five part menus:
3.1 Change the start point for the trolley motion
3.2 Change the end point for the trolley motion
3.3 Change the start point for blade motion
3.4 Change the end point for blade motion
3.5 Change the ramp time for the feed
Operator's Manual RC 455