15
TROUBLE SHOOTING
BEFORE YOU START WORKING FOR THE ELIMINATION OF DEFECTS, DISCONNECT THE
MACHINE FROM THE POWER SUPPLY.
Trouble
Motor does not run
Machine slows down during
working
Belt does not run centered
Vibration of the machine is
very strong
Sanding belt begins to rip
MANY POTENTIAL SOURCES OF ERROR CAN BE CLEARED BY THE EXPERTLY CONNECTION
TO THE ELECTRICITY GRID.
Should you in necessary repairs not able to properly to perform or you have
not the prescribed training for it always attract a workshop to fix the
problem.
HOLZMANN MASCHINEN GmbH
Possible cause
Incorrect power supply
Switch defect
Motor defect
Safety switch activated
Cables defect
Exerting too much pressure to
the sanding abrasive
Belt running not correctly
adjusted
Damage to bearings in grinding
roller
Stands on uneven ground.
Loosen Motorbracket.
Wrong running direction.
www.holzmann-maschinen.at
Let it be checked by a trained
person
Change
Change
Check
Change
Exert less pressure on the work
piece
Adjusted belt running
Replace grinding roller
Set to a new place.
Tighten motor bracket
Set the right running direction.
N O T E
TROUBLE SHOOTING
Solution
26
BTS 75-2