MAINTENANCE
14.3
Replace sanding belt
Disassemble the working table (sanding belt) (1).
Remove protection
cover
Loosen shaft nut (1) with an adequate tool Ø 8mm by
approx. half turn.
Loosen the tension of the sanding belt with the tension
screw (1) and push the roller backwards
Remove the sanding belt and mount a new sanding belt.
Reassemble the protection cover and the work table
(sanding belt).
HOLZMANN MASCHINEN GmbH
www.holzmann-maschinen.at
24
BTS 75-2