Werbung
Step 7:
Adjusting the pelvis support
The pelvis support air chamber can be inflated by pushing
the rocker switch (16) forward in the direction of travel to
the plus symbol and it can be deflated by pushing it to the
minus symbol.
Adjust the pelvis support so that the pelvis is supported
on the iliac crest without irritating pressure and is thus
kept upright. Too little support results in the pelvis being
tilted backwards and thus in flattening of the natural
lumbar column curvature, which is highly undesirable from
an anatomical point of view. On the other hand, excessive
support can lead to pressure marks and hollow back.
Your RECARO Comfort-Plus: With the anatomically correctly positioned pelvis support
you place your upper body in an upright position completely automatically and thus pre-
vent tiredness and muscle tension problems.
Step 8:
Adjusting the lumbar support
The lumbar support air chamber can be inflated by push-
ing the rocker switch (17) forward in the direction of travel
to the plus symbol and it can be deflated by pushing it to
the minus symbol.
The lumbar support continues the work of the pelvis
support (Step 7), by supporting the lumbar spine on the
propped-up pelvis. Its natural curve should be comple-
mented and supported by inflating the air chamber, with-
out using positive pressure.
42
Quicklinks ausblenden:
Werbung
Kapitel
