Guidance And Manufacturer's Declaration - Electromagnetic Immunity - Storz UI400 ENDOFLATOR 40 Gebrauchsanweisung

63
Hinweise zur
elektromagnetischen
Verträglichkeit (EMV)
Guidance and manufacturer's declaration – electromagnetic immunity
The ENDOFLATOR
The customer or user of the ENDOFLATOR
Immunity test IEC 60601 test level
Electrostatic Discharge (ESD) ± 6 kV contact
IEC 61000-4-2 ± 8 kV air
Electrical fast ± 2 kV for power supply lines
transient/burst ± 1 kV for input/output lines
IEC 61000-4-4
Surge ± 1 kV line(s) to line(s)
IEC 61000-4-5 ± 2 kV line(s) to earth
Voltage dips, short <5 % U
interruptions and voltage (>95 % dip in U
variations on power supply for 0.5 cycle
input lines
40 % U
IEC 61000-4-11
(60 % dip in U
for 5 cycles
70 % U
(30 % dip in U
for 25 cycles
<5 % U
(>95 % dip in U
for 5 seconds
Power frequency 3 A/m
(50/60 Hz)
magnetic eld
IEC 61000-4-8
* Note: U is the a.c. mains voltage prior to application of the test level.
T
Electromagnetic
Compatibility (EMC)
information
Table 2
®
40 model UI400 is intended for use in the electromagnetic environment speci ed below.
®
40 model UI400 should ensure that it is used in such an environment.
Compliance level
± 6 kV contact
± 8 kV air
± 2 kV for power supply
lines
± 1 kV for input/output lines
± 1 kV line(s) to line(s)
± 2 kV line(s) to earth
* <5 % U *
T T
) (>95 % dip in U
T
for 0.5 cycle
40 % U
T T
) (60 % dip in U
T T
for 5 cycles
70 % U
T T
) (30 % dip in U
T T
for 25 cycles
<5 % U
T T
) (>95 % dip in U
T
for 5 seconds
3 A/m
Electromagnetic environment – guidance
Floors should be wood, concrete or ceramic tile. If
oors are covered with synthetic material, the relative
humidity should be at least 30 %.
Mains power quality should be that of a typical
commercial or hospital environment.
Mains power quality should be that of a typical
commercial or hospital environment.
Mains power quality should be that of a typical
) commercial or hospital environment.
T
If the user of the equipment or system requires
continued operation during power mains interruptions,
) it is recommended that the equipment or system be
powered from an uninterruptible power supply.
)
)
T
Power frequency magnetic elds should be at
levels characteristic of a typical location in a typical
commercial or hospital environment.
( )