Operation - Kärcher KM 90/60 R LPG Adv Bedienungsanleitung

1 End stop left cover boundary
2 Bracket closure
3 Safety splint
4 Gas hose
2
3
1 Protective cover
2 Gas hose with union joint
3 Gas withdrawal valve
 Place the cylinder in such a way that the
connection threading of the locking
valve vertically points upwards.
Note: A fitting position towards the top
is important for the function of the gas
motor, it requires a gaseous extraction
from the gas bottle.
 Fasten the gas cylinder on the left cover
boundary (in the direction of travel).
 Close the bracket closure.
 Attach safety splint.
 Remove protective lid (1) from the con-
nection valve of the cylinder.
 Connect the gas tube with Union nut (2)
(use 30 mm spanner).
NOTICE
Connection has a left threading.
Warning
Open the gas drawing valve (3) only after
starting the appliance (refer chapter Start-
ing the appliance).
24
CAUTION
Risk of damage to the drive! Prior to each
run, ensure that the freewheel lever is in the
lower position.
CAUTION
The air inlets next to the driver's seat must
not be covered. Do not store any objects
next to or behind the seat.
WARNING
Long hours of using the appliance can
cause circulation problems in the hands on
account of vibrations.
It is not possible to specify a generally valid
operation time, since this depends on sev-
eral factors:
– Proneness to blood circulation deficien-
cies (cold, numb fingers).
– A firm grip impedes blood circulation.
1
– Continuous operation is worse than an
operation interrupted by pauses.
In case of regular, long-term operation of
the device and in case of repeated occur-
rence of the symptoms (e.g. cold, numb fin-
gers) please consult a physician.
Adjusting driver's seat
 Pull seat adjustment lever inwards.
 Slide seat, release lever and lock in
place.
 Check that the seat is properly locked in
position by attempting to move it back-
wards and forwards.
Programme selection
1 Driving
Driving to the Place of Use.
Side brush and roller brush are raised.
2 Sweeping with sweep roller
Roller brush is lowered.
3 Sweeping using roller brush and
side brushes
Roller brush and side brushes are low-
ered.

Operation

6
-
EN
Starting the machine
Note: The machine is equipped with a seat
contact switch If the driver's seat is vacat-
ed, the machine is switched off.
Note: If the seat contact switch has
switched off the machine, then turn the ig-
nition key to "0" to prevent battery dis-
charge.
 Open the device hood.
 Check, if the stop switch on the com-
bustion engine is in the "ON" position.
 Close cover.
Opening the gas supply (gas engine)
 Open the gas drawing valve by turning
it in anti-clockwise direction.
Turning on the Appliance
 Sit on the driver's seat.
 Do NOT press the accelerator pedal.
 Set programme switch to step 1 (driv-
ing).
 Turn ignition key past position 1.
 If the machine starts, release the igni-
tion key.
Note: Never operate the starter motor for
longer than 10 seconds. Wait at least 10
seconds before operating the starter motor
again.
Drive the machine
CAUTION
Always press the accelerator pedal careful-
ly and slowly. Do not jerkily change from re-
verse to forward drive or vice versa.
1 Accelerator pedal, "forwards"
2 Accelerator pedal, "reverse"
Drive forward
 Press slowly the accelerator pedal "for-
ward".
Reverse drive
Danger
Risk of injury! While reversing, ensure that
there is nobody in the way, ask them to
move if somebody is around.
 Press slowly the accelerator pedal "re-
verse".
2
1