Kärcher KM 90/60 R LPG Adv Bedienungsanleitung Seite 30

 Rear sealing strip
 Set the distance between the sealing
strip and the floor so that the bottom
edge trails behind at a distance of be-
tween 5 and 10 mm.
 If worn, replace.
 Unscrew retaining nuts for rear sealing
strip (3).
 Screw on new sealing strip.
 Side sealing strips
 Slightly loosen retaining nuts for the
side sealing strip (to replace, unscrew).
 Screw on new sealing strip without fully
tightening the nuts.
 To set the floor clearance, insert a
sheet with a thickness of between 1 and
3 mm under the sealing strip.
 Adjust sealing strip.
 Tighten nuts.
 Screw on side panels.
 Push in the waste containers on both
the sides and lock them.
Check/replace dust filter
WARNING
Wear a dust mask when working around
the dust filter. Observe safety regulations
on the handling of fine particles.
Note: Wait at least 1 minute before remov-
ing the dust filter so that the dust can settle.
 Open the device hood.
1 Screws (2x)
2 Lid with cleaning device
3 Support
4 Dust filter (flat-fold filter)
5 Suction blower
 Loosen the screws.
 Fold the lid up and secure it by means
of the support.
 Take out the dust filter.
 Check dust filter, clean or replace
 Insert cleaned or new dust filter.
 Close the lid.
 Tighten the screws.
Check suction blower
 Check hoses at the suction blower for
leaks and tight seating from time to
time.
30
Checking drive belt
 Turn ignition key to "0" and remove it.
Danger
The engine requires approx. 3-4 seconds
to come to a standstill once it has been
switched off. During this time, stay well
clear of the working area.
 Open the device hood.
V-belt axle drive (1) and V-belt suction
blower (2)
 Check the V-belt axle drive (1) and V-
belt suction blower (2) for tension, wear
and damage.
Drive belt (3)
 Check drive belt (3) for tension, wear
and damage.
Drive belt (4)
 Check drive belt (4) for tension, wear
and damage.
Circular belt side brush (5)
 Check circular belt side brush (5) for
tension, wear and damage.
12
-
EN
V-belt sweeping drive (6) and screw (7)
 Check V-belt of the roller brush drive (6)
for tension, wear and damage.
 Tighten the V-belt at the screw if neces-
sary.
Replacing fuses of drive control/
electronic system
The drive control/electronic system is in-
stalled behind the front panel. To replace a
fuse, the front panel must be removed.
 Loosen the front panel screws.
 Remove front panel.
 Replace defective fuses.
Note: The assignment of fuses is indi-
cated on the inside of the panel. Only
use fuses with identical safety ratings.
 Replace front panel.
F 1 Main fuse
Battery pole fuse
F 2 Printed board
F 3 Charge regulator
F 4 Printed board
F 5 Beacon light (optional)
F 10 Gas valve
125 A
7,5 A
15 A
25 A
7,5 A
7,5 A