Hilti PS 200 Bedienungsanleitung Seite 53

Place the scanner on the grid at the starting point shown
by the blinking arrow. Ensure the alignment marks on the
scanner are aligned correctly with the grid as shown below.
1
150
2
-NOTE-
Incorrect alignment of the scanner on the grid may lead
to the bar positions being incorrect on the generated
image.
Press Record and move the scanner along the first row.
Progress when scanning is shown by a thick black line
which advances on the display as the scanner is moved
over the surface.
The scanner will emit a double beep at the end of the
row, automatically stopping the recording. Repeat the
process for each row, observing the prompts on the
scanner display telling you to begin a new line.
Printed: 07.07.2013 | Doc-Nr: PUB / 5070389 / 000 / 00
5
150
When all rows are complete, scan the columns in a sim-
ilar way.
®
PS 200 S Ferroscan
The recording of any row or column may be interrupt-
ed before reaching the end by pressing Record again.
This may be required if an obstacle prevents scanning
of the full path. Similarly, an entire row or column may
be skipped by starting and stopping the recording with-
out running the scanner over the grid.
en
51