Herunterladen Inhalt Inhalt Diese Seite drucken

Adjusting The Carburettor; Storage; General Storage Instructions; Fold Up Device - FLORABEST FBME 575 A1 Handbuch

Vorschau ausblenden Andere Handbücher für FBME 575 A1:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Adjusting the
carburettor
The carburettor has been preset in
the factory for optimum performance.
If readjustments are required, have
the adjustments made by a specialist
workshop.

Storage

General storage
instructions
Do not store the equipment
with a full collection box. The
grass may start fermenting,
creating excessive heat. Risk
of fire.
• Remove the electric starter battery (9)
and keep it in a cool, dry place out of
the reach of children.
• Disconnect the charger and store in a
cool, dry area.
• Clean and service the equipment
before storage.
• Allow the engine to cool before storing
the equipment in enclosed areas.
• Use suitable and authorised containers
for storing fuel.
• Keep the equipment in a dry place that
is protected from dust and out of reach
of children.
• Do not wrap the equipment in nylon
bags as damp and mould could form.
Fold up the device
(Fig. A, T)
For space-saving storage, the grip rod can
be folded twice.
1. Remove the grass collection box (29).
2. Open the quick-release clamp (34) on
the upper handle (1) and the lower
handle (5).
3. Fold both handles down again.
The Bowden cable (6) and electric
starter cable (24) must not be jammed
when you do this.
Storage during the
winterbreak
Non-observance of the storage
instructions may cause starting
problems or permanent damage
as a result of fuel residues in the
carburettor.
• Start the engine and allow it to run
until it stops due to running out of
petrol.
• Change the oil (see "changing the engine
oil ").
• Preserve the engine:
- Unscrew the spark plug (17) (see
"cleaning and maintenance");
- Pour a tablespoon of engine oil
through the spark plug hole into the
engine compartment;
- Pull back on the blade control bar (2)
and hold it against the upper handle
(1). Slowly crank the engine several
times to distribute the oil inside the
cylinder.;
- Screw the spark plug (17) tight.
• Dispose of used oil and petrol residues
in an ecofriendly manner (see "Disposal/
environmental protection").
GB
IE
NI
33

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis