Setting The Required Function; Mowing; Working Instructions; General Working Instructions - FLORABEST FBME 575 A1 Handbuch

Setting the required
function (Fig. A, I, J)
Stop the machine and make sure
the blade has stopped completely.
Then remove the electric starter
battery.
This machine has 3 functions, collection,
mulching and side discharge, which can
be converted by changing accessories.
Please see the following chart for detail.
Mulching
plug
Collection
x
Mulching
√
Side
√
discharge
Note: √: installed x: uninstalled
Collection: The mower will transport all
cuttings into the collection box.
Mulching: The cuttings are further chopped
into very small clippings. The mower
will leave them on the grass, where
they will fertilize the lawn.
Side discharge: The cuttings will be
expelled to the side of the machine.
Mowing (Fig. A, I, J, L)
1. Set the required function and the
cutting height.
2. Start the engine (see "Engine start")
Push the machine forward to mow
the grass. Alternatively, use the
drive system for convenient mowing.
machine will propel itself when drive
control bar (3) is held against the
upper handle (1).
Side Grass
discharge collection
chute box
x √
x x
x
√

Working instructions

General working
instructions
• As far as possible, mow the lawn when it
is dry in order to protect the turf.
• Set the cutting height such that the
machine is not overloaded.
• Run the machine at walking speed or
self- ropelled speed in lines that are as
straight as possible. For best results, the
lines should always overlap by a few
centimetres.
• Do not move backwards.
• On slopes, always work across the
slope.
• If the blade comes into contact with
a foreign body, switch off the engine
immediately. Wait until the blade is
stationary and check the equipment
for damage. Restart work only if the
equipment is undamaged.
• Switch off the machine during longer
breaks and for transportation. Always
wait until the blade is stationary.
• Clean the machine after each use,
as described in the "cleaning and
maintenance" chapter.

Setting cutting height

(Fig. A, N)
Stop the machine and make sure the
blade has stopped completely.
The central height adjustment has seven
possible settings: 25 - 32 - 40 - 48 - 57 - 67
- 75 mm. To adjust:
GB IE NI
29