Setting The Cutting Height; Emptying The Grass Collection Box; Cleaning And Maintenance; Cleaning And General Maintenance Work - FLORABEST FBM 450 B2 Originalbetriebsanleitung

GB IE NI
• Clean the equipment after each use, as
described in the "cleaning and mainte-
nance" chapter.

Setting the Cutting Height

The equipment has 5 positions for setting
the cutting height (25-34-46-60-75 mm):
1. Pull the lever (17) outwards and
push it to the desired position
(33).
2. Push the lever (17) back in.
The correct cutting height is around
30 – 45 mm for an ornamental lawn and
around 40 – 65 mm for a utility lawn.
Select a greater cutting height for
Emptying the Grass Collec-
tion Box
Fill Level Indicator:
the top of the grass collection box (
shows when the grass collection box is full.
Fill level indicator open:
Grass collection box empty
STOP
Fill level indicator closed:
Grass collection box full
1. Stop the engine and wait until
the blade is stationary.
2. Lift the rear impact protection
(22) and remove the grass collec-
tion box (20).
3. Carry the box to your grass
disposal site and upend it. For
easy emptying, hold the box at
its lower handle.
12
24) attached to
20)
Cleaning and
Maintenance
Have any repair and mainte-
nance work not described in
these instructions carried out
by a specialist workshop. Use
only original replacement
parts. Risk of accidents!
Carry out maintenance and
cleaning work strictly with
the engine switched off and
spark plug connectors
removed. Risk of injury!
Allow the equipment to cool
before any maintenance and
cleaning work. Elements of
the engine are hot. Risk of
burning!
W ear gloves when handling the
blade.
For cleaning and maintenance
work, also observe the Briggs &
Stratton instruction manual supplied.
W e recommend contacting an au-
thorised Briggs & Stratton dealer for
maintenance work on the engine
(see Briggs & Stratton dealer list).
Cleaning and General Main-
tenance Work
Remove the grass collection box.
Fold the upper handle bar (1) and
tilt the device back for cleaning and
maintenance jobs at the bottom
side so that the spark plug faces
upwards.