Setting The Cutting Height; Emptying The Grass Collection Box; Cleaning And Maintenance; Cleaning And General Maintenance Work - FLORABEST FBM 135 A1 Originalbetriebsanleitung

GB

Setting the Cutting Height

The equipment has 10 positions for set-
ting the cutting height (30-75 mm):
1. Pull the lever (21) outwards and
push it to the desired position
(34).
2. Push the lever (21) back in.
The correct cutting height is around
30 – 45 mm for an ornamental lawn and
around 40 – 65 mm for a utility lawn.
Select a greater cutting height for
the first cut of the season.
Emptying the Grass Collection
Box
Fill Level Indicator:
The fill level indicator (
the side of the grass collection box (
24) shows when the grass collection box
is full.
Fill level indicator open:
Grass collection box empty
Fill level indicator closed:
Grass collection box full
1. Stop the engine and wait until
the blade is stationary.
2. Lift the rear impact protection
(8) and remove the grass collec-
tion box (24).
3. Empty (see "disposal / environ-
mental protection" chapter) and
reassemble the grass collection
box (24).
14
25) attached to

Cleaning and Maintenance

Have any repair and mainte-
nance work not described in
these instructions carried out by
a specialist workshop. Use only
original Grizzly replacement
parts. Risk of accidents!
Carry out maintenance and
cleaning work strictly with the
engine switched off and spark
plug connectors removed. Risk
of injury!
Allow the equipment to cool
before any maintenance and
cleaning work. Elements of the
engine are hot. Risk of burning!
Wear gloves when handling the
blade.
Cleaning and General Mainte-
nance Work
Tip the Equipment
(Service Position):
To clean the underside of the equipment,
tip the equipment backwards on the upper
handle bar (2).
To prevent the equipment from tipping
back,
- remove the grass collection box (
24) if it is installed.
- set the cut height to the highest posi-
tion (34),
- loosen the quick release tensioning
levers (26) and fold the top handle bar
(2) towards the equipment (see "As-
sembling the Handle Bar").
The Bowden cables (9) must not be
caught when doing this.