2� 6.7 Lowering Runway; Driving The Vehicle Out; 2� 6.9 Switch-Off - Bosch VLS 5140 Originalbetriebsanleitung

en �2 | �LS ��4� | Operation
6.7 Lowering runway
DANGER – Risk of vehicle falling or tilting!
Risk of (fatal) injury on lowering the runway and
the vehicle.
¶
Make sure there is no-one in the vehicle or
in the area of the lifting platform.
¶
Keep away from the lifting platform.
¶
Observe the lifting platform and vehicle.
¶
Make sure both runways are lowered evenly.
DANGER – Risk of crushing when lowering
runway!
Risk of (fatal) injury on lowering the runway.
¶
Make sure there is no-one in the area of the
lifting platform.
¶
Keep away from the lifting platform.
1. Remove all non-secured tools and other objects from
the vehicle and the lifting platform.
2. Set the mode selector switch to "1 Runway".
3. Press the "Lift" button (o) for approx. 1 second.
 The runway moves upwards slightly.
 The detent pins are retracted, the runway is re-
leased.
4. Keep the "Lower" button (u) pressed.
 The runway moves downwards for as long as the
button is pressed.
 Lowering of the runway is stopped automatically
at a height of 200 mm (foot protection safety lev-
el).
5. Check the area beneath the runway.
6. If it is safe to do so, press and hold the "Lower"
button (u) again.
 A warning signal sounds and the runway moves
down to the bottom position.
"
The runway and vehicle are now fully lowered.
|
1 689 989 122 2012-09-13
6.8

Driving the vehicle out

1. Make sure that the runway is completely lowered.
2. Make sure that the automatic roll-off guard on the
drive-on ramp is lowered.
3. Make sure that the exit area is unobstructed.
4. Drive the vehicle off the runway in a straight line.
"
The lifting platform is now empty.
6.9 Switch-off
Switch off the VLS 5140 by way of the master switch.
1. Set the master switch to the OFF (O) position.
2. Secure to prevent unauthorized switch-on.
"
Lifting platform is deactivated.
Robert Bosch GmbH