Assembly Of The Control Unit; Wall Mounting - EOS EMOTEC B6000 Montage- Und Gebrauchsanweisung

Assembly of the control unit

Wall mounting

Mount the control unit outside the sauna
cabin only. The most practical mounting
point would be the wall area onto which
the sauna oven is mounted on the inside,
except on the outside of the cabin. If elec-
trical conduits are present, mount the con-
trol unit accordingly. To mount the control
unit, please follow these instructions:
1. Remove the cover of the control unit. To
do this press the fastening tab inwards
with a fl at screwdriver and remove the
housing top by pivoting it upwards (Il-
lust.1). Drill the threaded holes for the
included 4 x 20 mm wood screws accor-
ding to Illust. 3 & 3.1.
2.Insert one of the wood screws into the
upper middle hole. This screw will be the
mounting point for the control unit. Make
sure the screw is projecting out from wall
about 3 mm. (Illust. 3.2)
3. Hang the control unit onto the 3 mm pro-
jecting screw. Insert the included rubber
sleeves into the openings on the back
side of the housing and lead the electri-
cal cable through these openings. Screw
the lower part of the housing onto the ca-
bin wall using the lower threaded holes.
(Illust. 4)
Illust. 1
GB
ca. 34 cm
19 cm
Illust. 3.1
threaded holes
upper threaded hole
feed-through channel for
power supply lead wire
oven supply line
vaporizer supply line
lamp
fan
Illust. 3
3
Illust . 3.2
feed-through
channel for
sensor lines
Illust . 4
27