Important Notes When Programming; Delayed Startup - EOS EMOTEC B6000 Montage- Und Gebrauchsanweisung

Important notes when programming

Every modifi cation of the preset parameters must be confi rmed by pressing the „MODE"
button.
If you do not press the „MODE" button, the unit will automatically default back to the pre-
vious parameters.
If you do not touch the unit for a longer period of time during programming, the display will
default back to standard and the illumination will cease after a short time.

Delayed startup

Using the time preset
sauna system to start up within 24 hours.
Always check for objects on
the sauna oven before starting
up the sauna. Fire hazard!
To select an alternate start-up time, press
the „MODE" button. The selection symbol
P1 appears on the display.
Press the „MODE" button again and you
see the actual start-up time.
Using the selection buttons
can now set heating time.
Please consider, though, that the cabin
needs 40-50 minutes for warming up, to
create a pleasant climate in the cabin. For
example, if you wish to take your sauna bath
at 6 p.m., then you should set the startup
time to 5:10 p.m.
Confi rm the selected time by pressing the
„MODE" button. P1 briefl y appears on the
display.
As long as P1 is shown on the display, press
the button to start the delayed start-up
sequence.
34
, you can set your
and you
P 1
15:00
17:10
P 1
GB