Programming Fan Operation - EOS EMOTEC B6000 Montage- Und Gebrauchsanweisung

Programming fan ope-
ration
This control unit lets you operate a fan.
By factory default, „no fan operation" is
specifi ed.
To program the fan function, fi rst press the
„MODE" button to reach the programming
mode.
Px then appears on the display.
Press the button repeatedly to reach the
program level P4. The fan symbol appears
on the display.
Confi rm by pressing the „MODE" button.
A „0" appears on the display (no fan ope-
ration).
By pressing the button, you can set a „1"
(fan operation).
Confirm your selection by pressing the
„MODE"..button. On the display appears
shortly P4, then the unit returns to its default
readout and in set value „1" the fan symbol
appears on the display.
P 3
P 4
20:00
without symbol =no fan operation
with symbol = fan operation
GB
0
1
37