Maintenance And Care; Lubricating The Jaws; Exchanging Jaws; Hydraulic Fluid Refill - Gesipa TAURUS 1 C Bedienungsanleitung

GB
12

Maintenance and Care

The complete jaw assembly must be regularly maintained.

12.1 Lubricating the jaws

• Disconnect the tool from the compressed air.
• Screw off steel head N° 2
• Dip the complete jaw housing into oil as far as N° 3 O-ring, or spray oil on Jaws N° 5.
• Reassemble in reverse order.

12.2 Exchanging jaws

• Disconnect the tool from the compressed air
• Screw off steel head N° 2
• Screw off jaw housing N° 4, while securing the stroke mechanism against turning!
• Remove jaws N° 5
• Clean jaw housing and grease friction surfaces
• Insert new jaws from the front (grease will hold in position)
• Reassemble in reverse order.
12.3 Hydraulic fluid refill
• Disconnect the tool from the compressed air
• Screw off steel head N° 2
• Screw off jaw housing N° 4, while securing the stroke mechanism against turning!
• Unscrew and remove fluid refill screw N° 38 c/w sealing ring N° 39, using a T20 Torx screwdriver
• Screw on included oil filling container with cover
• Reconnect the tool to the air pressure and depress yellow trigger once. Disconnect the tool from
compressed air
• Empty old oil from the oil container.
• Fill oil container with new hydraulic fluid, up to mark
• Move traction rod back and forth carefully several times by hand until oil escapes bubble-free. Push
traction rod fully back up to stop and leave in this position.
• Remove oil filling container and screw back sealing ring and refill screw
• Reconnect the tool to compressed air and depress trigger twice.
• Carefully loosen oil filling screw by 2 revs; Traction rod will move slowly up to forward stop. Wipe
away spilt oil.
• Retighten oil filling screw
• Screw on steel head N° 2
72