Herunterladen Inhalt Inhalt Diese Seite drucken

Maintenance And Care; Troubleshooting - Gesipa FireFox 2 Betriebsanleitung

Pneumatisch-hydraulisches blindnietmutternsetzgerät
Vorschau ausblenden Andere Handbücher für FireFox 2:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 3
GB
6.

Maintenance and care

The blind rivet nut setting tool must be kept in a dry place. Worn threaded mandrels must
be replaced as described under item 3.1, as required. After prolonged use it may become
necessary to top up or replace the hydraulic oil. To top up the hydraulic oil follow the sequence
of operations below:
Disconnect the blind rivet nut setting tool from the compressed air network
Unscrew nosepiece 2 using locknut 1
Set setting stroke to 10 mm (all lines on stroke scale 5 are visible)
Unscrew oil refill screw no. 12 and seal no. 13 using Torx screw driver T20
Unscrew supplied oil refill container with lid
Connect blind rivet nut setting tool to compressed air network and actuate trigger; then
detach blind rivet nut setting tool from compressed air network
Drain waste oil from oil refill container
Fill oil refill container up to mark with hydraulic oil
Move the thrust piston unit at threaded mandrel 3 carefully to and fro by hand until the oil
starts to escape bubble-free; push thrust piston unit all the way back to the buffer and leave
it there.
Unscrew oil refill tank and screw in oil refill screw 12 with seal 13
Connect the blind rivet nut setting tool to compressed air network
L oosen oil refill screw 12 carefully by c. 2 rotations; thrust piston unit will move slowly into
front end position. Catch any escaping oil with a rag!
Tighten oil refill screw 12
Screw down nosepiece 2, using locknut 1
Regular maintenance will extend the service life of your high-quality GESIPA
tools and they should be serviced at least every 2 years by an authorised
workshop or by GESIPA
recommend servicing ahead of schedule.
7.

Troubleshooting

Not possible to wind down nut
Cause
Nut thread defective
Threaded mandrel defective
Winding process does not start
24
Service. For tools that are used intensively, we
®
Remedy
Use new nut
Replace threaded mandrel (see item 3.1)
Increase setting stroke to minimum
®

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis