Herunterladen Inhalt Inhalt Diese Seite drucken

Aufbereitung; Pflege Und Handhabung; Reprocessing; Care And Handling - Storz TH 102 Gebrauchsanweisung

Kamerakopf für image1 s h3-z fi
Inhaltsverzeichnis

Werbung

13

Aufbereitung

7
Aufbereitung
Im folgenden Kapitel finden Sie Informationen zur
Pflege und Reinigung des IMAGE1 S™ H3-Z FI
Kamerakopfs.
7. 1

Pflege und Handhabung

Zur Erhöhung der Lebensdauer Ihrer Kamera
bitte die folgenden Anweisungen zur korrekten
Handhabung und Pflege des Kamerakopfes
befolgen:
DAS KAMERAKOPFKABEL NICHT
AN DEN PROZESSORANSCHLUSS
ANSCHLIESSEN, WENN ES FEUCHT
ODER NICHT SAUBER IST. Stellen Sie
immer sicher, dass der Stecker absolut
sauber ist. Entfernen Sie vor dem
Anschließen eventuelle Feuchtigkeit mit
einem sterilen Tuch.
DEN KAMERAKOPF NICHT AM KABEL
ANHEBEN. Heben Sie immer zuerst
den Kamerakopf an und nehmen Sie
anschließend Kabel und Stecker auf.
Das Kabel enthält verschiedene kleine
Adern und muss daher vorsichtig
behandelt werden.
DAS KAMERASYSTEM NICHT in
direktem Sonnenlicht oder bei hohen
Temperaturen LAGERN.
ACHTEN SIE DARAUF, DASS DAS
KABEL WÄHREND DER LAGERUNG DER
KAMERA NICHT ZU FEST AUFGEROLLT
ODER ZUSAMMENGEFALTET IST. Legen
Sie das Kabel immer locker in Schlaufen
mit einem Durchmesser von mindestens
15 cm (6").
ZIEHEN SIE NICHT STARK AM KABEL,
UM ES ABZUROLLEN. Dies könnte
zu unerwünschtem „Knicken" führen.
Rollen Sie das Kabel immer locker und
vorsichtig ab.
DAS SYSTEM VORSICHTIG
BEHANDELN und starke Stöße
vermeiden. Zum Transport die
Originalverpackung verwenden, um eine
Beschädigung des Geräts zu vermeiden.

Reprocessing

7
Reprocessing
The following chapter provides information on the
care and cleaning of the IMAGE1 S™ H3-Z FI
camera head.
7. 1

Care and handling

To maximize the life of your camera, please follow
the guidelines given below for the correct handling
and care of the camera head:
DO NOT PLUG THE CAMERA HEAD
CABLE INTO THE PROCESSOR
RECEPTACLE IF IT IS MOIST OR
NOT CLEAN. Always ensure that the
connector is completely clean. Remove
any moisture present with a sterile cloth
before connecting.
DO NOT PICK UP THE CAMERA HEAD
BY ITS CABLE. Always pick up the
camera head first, and then pick up and
support the cable and connector. The
cable contains many tiny conductors
and must therefore be handled with
care.
DO NOT STORE THE CAMERA
SYSTEM in direct sunlight or at high
temperatures.
ENSURE THAT THE CABLE IS NOT
COILED TOO TIGHTLY OR FOLDED UP
WHILE THE CAMERA IS IN STORAGE.
Always arrange the cable in loose coils
with a diameter of 6 inches (15 cm) or
more.
DO NOT PULL FORCEFULLY ON
THE CABLE WHEN UNCOILING.
Undesirable "kinks" may result. Always
allow the cable to uncoil gently and
loosely.
HANDLE THE SYSTEM WITH CARE,
avoiding any strong impacts. When
transporting, use the original packaging
to prevent damage to the device.
Preparación
7
Preparación
En el siguiente capítulo encontrará información
acerca de la conservación y la limpieza del
cabezal de cámara IMAGE1 S™ H3-Z FI.
7. 1
Conservación y manipulación
A fin de prolongar la vida útil de su cámara, siga
las siguientes instrucciones sobre el manejo y la
conservación de su cabezal de la cámara:
NO CONECTE EL CABLE DEL CABEZAL
DE LA CÁMARA A LA CONEXIÓN PARA
EL PROCESADOR SI DICHO CABLE ESTÁ
HÚMEDO O NO ESTÁ LIMPIO. Cerciórese
siempre de que el enchufe esté absolutamente
limpio. Antes de efectuar la conexión, elimine
toda posible humedad con un paño estéril.
NO LEVANTE EL CABEZAL DE LA
CÁMARA ASIÉNDOLO POR EL CABLE.
Levante siempre en primer lugar el
cabezal de la cámara y, a continuación,
el cable y el enchufe. El cable ha de
manipularse con cuidado, puesto que
contiene varios conductores pequeños.
NO ALMACENE EL SISTEMA DE
CÁMARA en lugares expuestos a luz
solar directa o a altas temperaturas.
COMPRUEBE QUE EL CABLE NO
FORME UN ROLLO DEMASIADO
APRETADO O QUEDE DOBLADO
DURANTE EL ALMACENAMIENTO DE
LA CÁMARA. Disponga el cable de modo
que forme rollos flojos con un diámetro
mínimo de 15 cm (6").
NO TIRE FUERTEMENTE DEL CABLE
PARA DESENROLLARLO. Esto podría
ocasionar "dobleces" indeseadas en el
cable. Desenrolle el cable siempre con
cuidado y flojamente.
MANIPULE EL SISTEMA
CUIDADOSAMENTE y evite golpes fuertes.
Con el fin de evitar el deterioro del aparato,
utilice el embalaje original para transportarlo.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis