Hangar 9 Valiant 10cc Bedienungsanleitung Seite 24

131. Secure the tubing to the tube from the stopper using thin
locking wire or a tie wrap. This will keep the tubing from
sliding loose inside the tank. Use the clunk and tubing
included with the engine.
132. Secure the tubing to the clunk using thin wire. This will
keep the tubing from sliding loose inside the tank.
133. Insert the stopper fully into the tank. Check that the clunk
can move freely in the tank. The tube to the clunk can be
moved in our out to fi ne-tune the position of the clunk
inside the tank. Once set, tighten the screw using a #1
Phillips screwdriver to secure the clunk in the tank.
 Apply a very small amount of soapy water to the
stopper to make it easier to install the stopper into the tank.
134. Secure a 5-inch (127mm) fuel line to the fi ll line of the
tank. The overfl ow line can be attached to the vent, as
well as the remaining tubing to the clunk line that will
eventually attach to the carburetor. Tie wraps can also be
used to secure the fuel lines as well as wire ties.
135. Mount the fuel tank in the fuselage. Mount the fi ll fi tting
in the side of the fuselage using a fuel dot. Route the line
from the clunk through the opening in the fi rewall.
EN
131.
132.
133.
134.
135.
136. Install the fuel fi lter in the line to the carburetor. The fuel
line can then be secured to the carburetor.
 Once the engine has been installed,
skip to the Cowling Installation section.
 RECEIVER INSTALLATION FOR ELECTRIC
POWERED AIRCRAFT
137. Plug in the extensions for the fl aps and ailerons into the
correct ports of the receiver.
138. Secure the receiver in the fuselage. Make sure to follow
any additional instructions included with the receiver.
139. Secure the remote receiver in the fuselage.
 ELECTRIC POWER SYSTEM INSTALLATION
140. Place the mounting template on the fuselage. Use a
5/32-inch (2mm) drill bit to drill the holes necessary to
mount your particular motor choice.
24
136.
137.
138.
139.
140.