Hangar 9 Valiant 10cc Bedienungsanleitung Seite 16

51. Use medium grit sandpaper to lightly sand the joiner wire
where it contacts the elevators. Use a paper towel and
isopropyl alcohol to remove any oils or debris from the
joiner wire. This will provide a clean, rough surface so
the epoxy can properly bond to the wire
52. Test fi t the joiner wire to the elevators. The hinge line
must be straight along both elevators, and both elevators
must lay fl at on your work surface. If not, remove the
joiner wire and gently bend it to align the elevators.
 TIP: Use a small amount of tape to hold the joiner
wire secure while checking the alignment of the elevators.
53. Apply epoxy in the slot and hole for the joiner wire.
Prepare both elevators at this time.
 Use 15-minute or 30-minute epoxy to allow enough
working time during the joiner wire installation.
54. Apply epoxy to the joiner wire where it will come in
contact with the elevator. Apply the epoxy in preparation
for installation in both elevators.
55. Insert the joiner wire in the elevators. Use a paper towel
and isopropyl alcohol to remove any excess epoxy before
it cures.
EN
51.
52.
53.
54.
55.
56. Use low-tack tape to hold the joiner wire tightly in
position until the epoxy fully cures.
57. Once the epoxy cures, remove the tape from the
elevators. Use a pin vise and 1/16-inch (1.5mm) drill bit
to drill holes in the center of the hinges slots in both the
elevators and stabilizer.
58. Prepare the elevator hinges using T-pins and install the
hinges in the elevators.
59. Apply thin CA to the top and bottom of each hinges.
Follow the procedure outlines for the aileron hinges to
check the and break-in the hinges.
 WING AND STABILIZER INSTALLATION
60. Remove the top hatch from the fuselage.
16
56.
57.
58.
59.
60.