Hangar 9 Valiant 10cc Bedienungsanleitung Seite 14

31. Center the aileron servo using the radio system. Place
the servo arm so the arms are parallel to the servo
centerline.
32. Use side cutters to remove any unused arms that will not
protrude through the aileron servo cover. Install the servo
arm screw to secure it to the servo. Enlarge the hole
that is 1/2 inch (13mm) from the center of the servo arm
using a pin vise and 5/32-inch (2mm) drill bit.
33. Secure the servo to the cover using a #1 Phillips
screwdriver and the screws provided with the servo.
34. Secure an 9-inch (230mm) servo extension to the
servo using string or a commercially available fastener
(SPMA3054).
35. Tie or tape the string located inside the wing to the end
of the servo lead.
EN
31.
32.
1/2 inch
(13mm)
33.
34.
35.
36. Use the string to pull the servo lead through the wing and
out at the root.
37. Secure the servo to the wing using four M2 x 10 sheet
metal screws. Use a #1 Phillips screwdriver to tighten
the screws.
 AILERON AND FLAP CONTROL HORN AND
LINKAGE INSTALLATION
38. Separate the fl ap and aileron linkages. The fl ap linkage
9
measures 2 / inches (58mm), and the aileron linkage
32
measures 2 1 / inches (64mm) when the clevises are
2
removed.
39. Repeat the procedure to install the fl ap servo. Make sure
to center the fl ap servo before installing the servo arm.
 If your radio has a two-position flap
switch, set the throw to 0% for both the up
and down positions to center the servo.
40. Use a straight edge or ruler aligned with the edge toward
the wing tip of the slot for the servo arm to mark the
locations for the aileron control horn. Mark the location
for the control horn using a felt-tipped pen.
14
36.
37.
38.
9
2 / inch
32
(58mm)
2 1 / inch
2
(64mm)
39.
40.