Hangar 9 Valiant 10cc Bedienungsanleitung Seite 11

 FLAP INSTALLATION
1. Use a piece of low-tack tape to hold the aileron in
position.
2. Apply a small amount of petroleum jelly to the fl ex point
of the hinge to prevent epoxy from entering the hinge.
 Use care to only apply the petroleum jelly to the flex
point. If applied to the hinge portion it could cause the epoxy
not to adhere to the hinge, resulting in a poor glue joint.
3. Test fi t the hinge to the fl ap. Do not use any adhesives at
this time. Slide the hinge into position. Position as shown,
checking to make sure it can move freely.
4. Insert all four hinges in the fl ap at this time.
5. Fit the fl ap to the wing using the hinges.
Valiant ™ 10cc
1.
2.
3.
4.
5.
6. Check the fi t of the fl ap to the wing. The top of the fl ap
will align to the top of the wing. It will also line up with
the aileron.
 Use 15-minute or 30-minute epoxy to allow
enough working time during the hinge installation.
7. Remove the fl ap from the wing and remove the hinges.
Apply epoxy into each of the holes in the fl ap.
 Do not use an excessive amount of epoxy
when gluing the hinges so that it expels from the
hinge. Also make sure to use enough epoxy so it
securely adheres the hinge to the surfaces.
8. Apply epoxy to each hinge where it will be inserted into
the fl ap. Insert the hinges as shown in Steps 3 and 4.
9. Apply epoxy into each of the holes in the wing.
10. Apply epoxy to each hinge where it will be inserted into
the wing. Fit the fl ap to the wing as shown in Steps 5
and 6.
 Glue one flap at a time to prevent the
epoxy from setting prematurely.
11
6.
7.
8.
9.
10.
EN