Hangar 9 Valiant 10cc Bedienungsanleitung Seite 12

11. Use a paper towel and isopropyl alcohol to remove any
excess epoxy before it can fully cure. Use care not to get
epoxy in the moving part of the hinge or between the fl ap
and wing. Continue once the epoxy has fully cured for
both sets of fl ap hinges.
 AILERON INSTALLATION
12. Remove the tape and aileron from the wing panel.
13. Use a pin vise and 1/16-inch (1.5mm) drill bit to drill a
hole in the center of each hinge slot. Drill the hole 1/4-
inch (6mm) deep into the wood. Drill holes in both the
wing and aileron hinges slots at this time.
14. Insert a T-pin in the center of each of the aileron hinges.
 The T-pin will center the hinge equally
between the aileron and wing.
15. Insert the hinges in the slots in the aileron. The T-pin will
center the hinges so equal portions of the hinges are in
the wing and aileron.
EN
11.
12.
13.
14.
15.
16. Fit the aileron to the wing using the hinges. Remove the
T-pins and press the aileron tightly against the wing
reducing the gap between the wing and aileron to as
small as possible.
17. Check the gap between the fl ap and aileron, and the
wing tip and aileron. The gaps must be equal before
applying CA to the hinges.
18. Apply thin CA to the top of each of the hinges. Make sure
to fully soak the hinges so the CA can wick into the hinge
and bond to the surrounding wood.
 Use thin CA so it wicks into the hinge. A thicker CA
will not wick into the hinge properly. Do not to allow the
CA to run over the covering on the wing and aileron.
19. Complete gluing the hinge by applying CA to the bottom
of the hinges as well.
 Do not use CA accelerator on the hinges. The CA
must be allowed to soak into the hinge for the best
bond between the hinge and surrounding wood.
20. Allow the CA to cure for 10 to 15 minutes. Gently pull on
the fi xed surface and control surface to make sure the
hinges are glued securely. If not, apply additional CA to
secure each of the hinges.
12
16.
17.
18.
19.
20.