Hangar 9 Valiant 10cc Bedienungsanleitung Seite 13

21. Move the aileron through its range of throw to break in
the hinges. Check both the up and down movement of
the hinges before proceeding.
 AILERON AND FLAP SERVO INSTALLATION
22. Install the grommets and brass eyelets in the servos.
Follow any instructions included with the servo. Prepare
both the fl ap and aileron servos at this time.
23. Remove the aileron servo cover from the wing.
24. Use a hobby knife or other sharp tool to puncture the
covering at the screw holes that will secure the cover to
the wing.
25. Place the cover back into position using the arrow made
earlier to ensure their correct orientation. Use a pin vise
and 1/16-inch (1.5mm) drill bit to drill the mounts for the
servo covers. Use care not to drill through the covering
on the top of the wing.
Valiant ™ 10cc
21.
22.
23.
24.
25.
26. Thread an M2 x 10 sheet metal screw into each hole
using a #1 Phillips screwdriver. Remove the screws
before proceeding.
27. Apply a small amount of thin CA to harden the threads
made in the previous step. Allow the CA to fully cure
before installing the aileron servo cover.
28. Check that the vertical servo mount is glued securely to
the servo cover. If the mount is not secure, use a small
amount of medium CA or epoxy to securely adhere the
servo mount to the cover.
29. Fit the servo between the servo mounting tabs in the
aileron servo tray. The servo arm will be centered in the
slot. Mark the locations for the servo mounting screws
using a pencil, then remove the servo.
30. Use a drill and 5/32-inch (2mm) drill bit to drill the holes
for the servo mounting screws. Make sure to harden the
holes using the technique outlined in Steps 28 and 29.
Use the screws provided with the servo and a #1 Phillips
screwdriver when installing the screws.
13
26.
27.
28.
29.
30.
EN