Description And Use / Parts Of The Appliance - Vortice Climaticum Energy I 9 Betriebsanleitung

DESCRIPTION AND USE / PARTS OF THE APPLIANCE

The air conditioning system is made of 2 units
(referred to as Internal and External Unit), connected
to one another by means of copper tubes (with
adequate insulation), and a power cable (fig. 1).
The remote control supplied with the equipment
enables the user to control the unit remotely.
Internal Unit
1 Front panel
2 Air Inlet
Air filter
3
4 Air Outlet
5 Adjustable fin
Vertical grille
6
Display
7
8 Remote control receiving sensor
Remote Control
9
Manual control button
10
External Unit
Coolant connection pipes, condensate drain pipe
11
and power supply cable
12 Air Inlet (side and rear)
13 Air Outlet
Note:
When restarted, the unit runs with the settings
salved before it was turned off.
This occurs also if the unit turns off due to
sudden voltage drops, thanks to the automatic
Restart device fitted on the unit.
The automatic protection device of the
compressor prevents the appliance from being
restarted for approximately 3 minutes after it has
been turned OFF.
18
The Internal Unit is installed on the wall of the room
that needs to be conditioned.
The External Unit is placed outside the room that has
to be conditioned and installed on the floor or
mounted on the wall by means of special brackets.
Internal Unit
1 2
4
5
6 8
7
External Unit
12
13
3 10
11