Switching Off; Charging Procedure - CareFusion MicroLab Betriebshandbuch

Switching Off

The unit is switched off by pressing the On/Off button.
The unit can be disconnected from the mains by unplugging the
charger from the mains socket or unplugging the USB cable if no
mains supply is connected.

Charging Procedure

The MicroLab's internal batteries are discharged when shipped from
the factory and should be fully charged on first use. Plug the AC
adapter into the mains supply and plug the adapter output plug into
the power input socket on the right hand side of the instrument. The
orange charging light next to the power input socket will flash to
indicate charging and will turn on constantly to indicate full charge.
The batteries will take approximately 4 hours to become fully
charged.
Note: Use only the AC adapter supplied. Use of any other type may
cause permanent damage to the MicroLab and cause a fire or
electrical hazard. Do not plug in and remove the power lead from
the AC adapter repeatedly.
Please Note: Dispose of the waste battery in accordance with EU
Waste Battery Regulations.
77