GAS GAS FSR 450 2008 Betriebsanleitung Seite 118

5. Before replacing the oil filter, make sure that the spring (E) and
the o-ring (F) are in the correct position.
6. Replace the filter cover and put the screws that secure the cover,
but without tightening them too hard (do not exceed the recommended
torque).
(H)
(G)
7. Check the oil inlet filter. To do so, remove the cover of the oil inlet
filter (G), clean the filter and check the O-rings. Install the filter again
and replace the cover.
8.Replace the cover of the crankcase and tighten it. Add approximately
1,200 ml of new oil through the orifice in the ignition cover (H).
The engine may be damaged if the oil is not used properly or the
specifications recommended by GAS GAS MOTOS are not followed.
Use the type of oil specified in the section on Petrol and Oil
recommendations.
9. Start the engine and allow it to run for a few minutes. Check that
no oil is lost through the filter cover. Stop the engine.
10. Check that the oil level is correct: stand the motorbike on a level
surface and check that the oil covers the observation hole (I).
11. If more oil is needed it can be topped up through the opening
in the ignition cover (H).
(I)
45
- -
WARNING