Troubleshooting; Technical Data - Cleanmaxx HJX1406-D Gebrauchsanleitung

EN

Troubleshooting

If the device should stop working properly, fi rst check whether you are able to correct
the problem yourself.
Do not attempt to repair a defective electrical device yourself!
Problem
The vacuum clean-
er has no suction
power.
The suction perfor-
mance is poor.
The device emits
dust when vacuum-
ing.
The mains cable
will not completely
retract.
An unpleasant odour
develops when vacu-
uming.

Technical Data

Article number:
Model number:
Voltage supply:
Power:
Protection class:
26
Possible cause/solution
• Is the mains plug not correctly connected with a socket?
Correct the position of the mains plug.
• Is the socket defective? Try another socket.
• Check the fuse for your mains connection.
• Is the auxiliary air vent on the handle open? Close it.
• Is the dust container too full? Empty the container.
• Are the fi lters heavily laden with dirt? Clean the cyclone
insert and the fi lters.
• Is the nozzle, telescopic tube or suction hose clogged?
Turn the device off, pull the mains plug out of the socket
and remove the obstruction.
• Has the dust container not been closed properly and/or is
it not (properly) inserted in the device? Correct this.
• Are the fi lters heavily laden with dirt? Clean the cyclone
insert and the fi lters.
• The mains cable has not been correctly retracted into the
device. Pull it out a little and press the cable retraction
button again.
• Are you using the device for the fi rst time? An odour often
develops when using new devices for the fi rst time. The
odour should disappear once you have used the device
a few times.
Z 09674
HJX1406-D
220 – 240 V~, 50 / 60 Hz
1000 W
II
Customer Service / Importer:
DS Produkte GmbH
Am Heisterbusch 1
19258 Gallin
Germany
Tel.: +49 38851 314650
(Calls to German landlines are
subject to charges. The cost varies
depending on the service provider.)