BADU Profi Eco VS Bedienungsanleitung Seite 19

WG27.50.008-P
Notice: The speed cannot be changed during the priming
phase.
WG27.50.009-P
WG27.50.010-P
05|2017
Setting the speeds:
Press the button of the fixed speed
that is to be changed ("1", "2" or
"3") and then change the speed by
using the "▼ ▲" buttons. The set
speed is stored directly and
approached immediately when the
fixed speed is selected again.
Setting the parameters:
You change to the setup menu by
pressing the "Setup" button for 3
seconds. There the "Info" button can
be used to scroll through the menu.
The first position of the display
shows the current menu item and the
remaining four positions the
parameter to be set.
If the "S" button is pressed within the
menu, all the changed values are
stored and the setup menu exited.
The text "StorE" is shown in the
display.
If you press the "0" button, the setup
menu is exited without the changed
values being stored.
Priming parameters:
The speed is set under the menu
item "n" while the time during the
priming phase is set under the item
"t".
"t oFF" = no priming phase
from oFF, 1 - 10 minutes can be set
EN 19