BADU Profi Eco VS Bedienungsanleitung Seite 18

1
2
3
WG27.50.006-P
The software version "-rX.X-" is displayed briefly when the
supply voltage is switched on.
WG27.50.007-P
EN 18
User interface:
(1) LED display: displays the
current speed of the motor.
4
(2) "1, 2, 3" button: selection of the
preset speeds.
6
(3) "INFO" button: to display the
5
current consumption and select
the parameters in the setup.
(4) "Setup" button: to set the
parameters.
(5) "▼ ▲" buttons: to change the
speed
.
(6) "0" button: to stop the motor.
Operation:
Press the button "1", "2" or "3" to
select the preset fixed speed.
If the pump starts from a standstill, it
starts up in priming mode (in far as it
is activated) and subsequently with
the selected fixed speed.
As long as the pump is in the priming
phase a bar moves in the first
position on the display from the
lower, through the middle to the
upper position.
During operation the pump is started
up to the fixed speed directly, without
priming time.
The motor is stopped by pressing the
"0" button. The "Power" LED flashes
and the display shows "oFF".
05|2017