Moving The Balance; Transporting The Balance - Sartorius Quintix Installations- Und Bedienungsanleitungen

Moving the Balance

Before moving the balance, switch it to the standby mode first, then
unplug the power connector and remove the weighing pan and the
pan support from the balance.
Moving the Balance over Short Distances in the Lab
t
Hold the balance under the housing,
lift it up carefully, and carry it to its
new location.
h
The balance needs to be re-leveled and adjusted each time
its setup location is changed.

Transporting the Balance

h
Prior to shipping, switch the balance to standby mode
(see next page) and then pull the plug.
h
Please use the original packaging for shipping.
Packaging can be ordered through the Sartorius Service
Center if required.
t
Secura Models: Remove the following parts from
the balance:
1
– Draft ring (1) for models with 0.1 mg
2
readability
3
– Weighing pan (2)
4
– Pan support (3)
5
– Centering ring (4) for models with
6
0.1 mg readability
– Shield disk (5)
– Remove glass panels from the draft
shield (6): see next chapter, "Care and
Maintenance."
t
Quintix and
Remove the following parts from
Practum Models:
the balance:
– Weighing pan (1)
1 – Pan support (2)
– Shield disk (3)
2
– Remove glass panels from the draft
3
shield (4): see next chapter, "Care and
4 Maintenance."
Avoid glass breakage,
shocks, and vibrations:
Never lift and carry the
balance by its draft
shield.
Installation and Operating Instructions Secura, Quintix, Practum
t
Turn the draft shield lock to
"unlocked."
t
Next, remove the wind shield from
the balance.
B
A
t
Put packing pads over the glass
panels
t
Insert the AC adaptor from the
cardboard box into the packing pad.
t
Put the top part of the packaging
over the device parts.
t
Next, put the packaged balance into
the cardboard box and seal the box.
English
t
Insert the bottom part
of the packaging into the
box.
t
Place the following parts
into the bottom part of the
packaging:
– Draft shield
– Balance
– Base plate
– Side panels
– Top glass cover
t
Insert the respective
weighing pan and pan
support into the opening
shown in the image to the
left:
– A = Weighing pan and pan
support with a diameter of
120 mm
– B = Weighing pan and pan
support with a diameter of
90 mm
7