Description Of The Functions; Cleaning Stop - WimTec SanTec OCEAN W7 Montage- Und Bedienungsanleitung

EN

Description of the functions

Cleaning stop:

DIP switch 3
Serves to disable the fitting prior to cleaning.
DIP switch 3 ON = Cleaning stop function enabled (default setting).
DIP switch 3 OFF = Cleaning stop function disabled.
Enable cleaning stop
Position your hand approx.
4 cm in front of the infrared
sensor (below the spout).
After 2 s, the ON/OFF icon
will start to pulse.
In the meantime, use your
free hand to tap the
ON/OFF icon and thus
enable the cleaning stop.
While the cleaning stop
function is enabled, the
illuminating icon will light up
two times every 3 s.
30 Wall tap control
OCEAN W7
Disable cleaning stop
The fitting will resume normal
operation 3 min after the sen-
sor has remained untriggered.
To instantly end the cleaning
stop, perform the same steps
used to enable the function.
SanTec OCEAN W7
Werkseinstellung:
ON
ON
OFF
OFF
1 2 3 4 5 6
ON
ON
OFF
OFF
1 2 3 4 5 6
ON
ON
OFF
OFF
1 2 3 4 5 6
ON
ON
OFF
OFF
1 2 3 4 5 6
ON
OFF
1 2 3 4 5 6
1 2 3 4 5 6
1 2 3 4 5 6
1 2 3 4 5 6
1 2 3 4 5 6