WimTec SanTec OCEAN W7 Montage- Und Bedienungsanleitung Seite 24

EN
Assembly
13
16
!
ATTENTION!
Perform the following steps
in the order indicated!
24 Wall tap control
OCEAN W7
14
17
13.
Connect the magnetic valve to the electronics module.
14. Connect the infrared sensor (broad plug) between the glass
front plate and the electronics module.
15. Connect the power supply (narrow plug) between the glass
front plate and the electronics module. Then switch on the
power (causing the safety locking mechanism of the magne-
tic valve to activate).
16.
Insert the electronics module into the designated slot.
17. Open both integrated stop valves using a screwdriver.
18. Place the mixing shaft and mixing dial into the central
position – both the dot and knob should point upwards.
SanTec OCEAN W7
15
18