Assembly
19
> Click <
22
19.
Put the glass front plate into place by carefully pushing in
inwards (click-lock system).
20.
Check whether the front plate is level.
If not, correct the alignment as described on page 26.
21.
Place the spacer ring over the outlet pipe towards
the front plate.
22.
Place the chrome spout over the outlet pipe and arrest it at
the bottom using the Allen screw (inbus SW 03).
23.
Open the main water valve.
24.
Perform a system test.
OCEAN W7
9 20
23
21
Page 26
24
Perform the following steps
in the order indicated!
SanTec OCEAN W7
Wall tap control
EN
!
ATTENTION!
25