WimTec SanTec OCEAN W7 Montage- Und Bedienungsanleitung Seite 23

Assembly
7
10
7.
Remove the outlet fixing screw (inbus SW 03).
8. Place the brass outlet pipe into the designated opening.
9. Fasten the outlet pipe in place using the fixing screw
(inbus SW 04).
10. Feed the connection cable (cable type: 2 x 0.2–0.5 mm
the flush-mount set and connect it to the power supply (art.
no. 117 899 or art. no.
Attention: The power must be switched off, and the
power supply must not be assembled in the flush-mount
set or the protected zone!
11. Configure the desired functions at the electronics module
(see p. 21).
12. Connect the power cables to the electronics module. Make
sure to use the correct polarity (+/-).
OCEAN W7
8
11
).
113 792
9
9
12
Perform the following steps
in the order indicated!
) into
2
SanTec OCEAN W7
Wall tap control
EN
+
-
!
ATTENTION!
23