InterCo AKTIVLINE Bedienungsanleitung Seite 57

zoid-shaped adapter receptacle after placing the seat
shell� First release the seat shell fixation by pulling
out the snap lock and turning it by 90 degrees� Position
the back end of the trapezoidal adapter to the front side
of the trapezoid-shaped adapter receptacle so that the
lock is pressed downwards�
Now push the set shell to the back until this engages
audibly� Relock the seat shell fixation by rotating the
snap lock through 90 degrees until it engages� Finally,
check the seat shell and the seat shell locking system
to ensure they are secure�
Now fix the security pin which connects the back unit
of the seat shell to the undercarriage�
Important!
Always check whether the seat shell
is firmly fitted to the trapezoid-shaped
adapter receptacle� Check this by pulling the seat
shell and simultaneously pressing on the under-
carriage� The seat shell may not slip out�
Removing the seat shell
First, pull out the two snap locks and turn through 90
degrees� Remove the security pin which connects the
back unit of the seat shell to the undercarriage� You
will now be able to move the seat shell system forward
and detach it from the adapter� Before reinstalling the
shell, remember to turn the locking pins 90° again in
order to reset them in the 'closed' position� Be careful
that the security pin connecting the back unit with the
undercarriage is again moved into place and that it is
correctly set and adjusted�
AKTIVLINE undercarriage, foldable
®
Folding mechanism for transporting the SIMPLY LIGHT
SIMPLY LIGHT is equipped with a folding mechanism in
order to make transport easier� The back unit including
push bar, is folded forward; it is also possible to remove
the back wheels�
To do this, gently step on the black cross bar at the

rear back part and simultaneously press the push
bar forwards�
Now you can remove the wheels�

AMF force application point system
See chapter on "Transport"
Anti­tip
The anti-tip is already factory-mounted� It is not pos-
sible to perform any readjustments�
Wheel protectors
The wheel protectors cover the upper part of the
wheels� They consist of a plastic mudguard which is
screwed to an aluminum mounting plate� For fitting
to the chassis, the free end of the mounting plate is
inserted into the upper slot of the wheel mounting�
To mount the wheel protector, proceed as follows:
Take the wheel protector and place the groove-

shaped part of the plate into the upper groove of
the axle block�
Insert the wheel protector to the stop� You can feel

a slight click when the plate engages in the guide�
Repeat this procedure on the other side�

For disassembly, pull the wheel protector off in

upward direction�
ASSEMBLY / ADJUSTMENT / OPERATION
57