InterCo AKTIVLINE Bedienungsanleitung Seite 48

To adjust the inclination angle of the push bar, proceed
as follows:
Loosen the two clamp levers located in front of the

pivot point for the push bar folding mechanism by
turning them counterclockwise�
Apply (axial) pressure to the clamp lever and press

the coach bolts out of the guide on the ratcheting
element until it is possible to freely adjust the incli-
nation adjustment angle�
Move the push bar into the desired position�

Important!
Apply pressure to the rounded head in
order to press the square head of the
screw into the ratcheting element at the required
inclination angle�
Check that the carriage bolt is correctly seated in

the ratcheting element�
Secure the unit in this position by turning both

clamp levers clockwise to tighten them� It is also
possible to maintain the inclination angle of the
back unit, including the push bar unit, when the
push bar is folded down (e�g� during transport)�
Trapezoid-shaped adapter receptacle and adapter
The seat shell is mounted to the undercarriage by
means of an adapter system� This system consists
of a trapezoidal adapter, which is mounted to the un-
derside of the shell, and a trapezoid-shaped adapter
receptacle which is connected to the undercarriage�
The adapter is securely locked using two spring-loaded
catch mechanisms which snap into the adapter bracket
from underneath� Always check to ensure that both
spring-loaded catch mechanisms are securely locked
on the adapter system�
If you should discover that the spring-loaded catch
mechanisms have become loose, then these should
48
ASSEMBLY / ADJUSTMENT / OPERATION
be re-tightened using an appropriate tool until the shell
is securely positioned on the undercarriage�
Tilt-in-space mechanism via two gas-pressure
springs
SIMPLY and SIMPLY LIGHT are equipped with a gas-
pressure spring adjustment for the inclination/tilting
of the seat shell�
To adjust the tilt of the seat, proceed as follows:
Activate the parking brakes�

In case of only one release lever: pull the gas-

pressure spring release lever mounted to the right
of the push bar frame�
In case of two release levers: pull both the gas-

pressure spring release levers mounted to the
right and left of the push bar frame simultane-
ously�
Adjust the inclination angle of the seat shell by

pulling the push bar up or pressing it down while
pulling the release lever for both gas-pressure
springs�
Let go of the release lever to lock the seat shell

into the adjusted inclination position�
Deactivate the parking brake, as appropriate�

Important!
Never pull the release lever without a
firm grip on the push bar if a patient is
seated in the wheelchair� Prior to inclination of the
seat shell, ensure that both anti-tipping wheels
always face in direction of the driving surface�
In a further undercarriage variant, the tilt of the
seat shell is adjusted with a telescopic unit� First
the mounting of the unit is loosened and the tele-
scopic tube moved either upwards or downwards,
depending on how the tilt is to be adjusted� Then
the unit is refastened�