Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Example:
The following figure shows the contents of the file 'DEMO.PRG'. This programmed show calls the ILD files
'DEMO1.ILD', 'DEMO2.ILD' and 'DEMO3.ILD' in succession. The first number after the file name indicates
the scanner speed, the second number controls the number of repetitions for each ILD file.
DEMO1.ild,12,3
DEMO2.ild,20,1
DEMO3.ild,18,4
DMX Operation
For operation with a controller with DMX512 protocol, the laser is equipped with 13 control channels. To be
able to operate the laser with a DMX controller, the DMX starting address must be set for the first DMX
channel. Press [FUNC] repeatedly until the display shows 'MODE: DMX', then press [ENTER]. Now you can
adjust the number of the first DMX channel (DMX address) used by the unit. Select a value between 1 and
512 using the [UP] and [DOWN] buttons. Press [ENTER] to store the value and to start operation in DMX
mode.
Note:
The starting address depends upon which DMX controller is being used. Please refer to the controller's
documentation.
Master/Slave Operation with Lasers
When several lasers are interconnected, the slave units can be synchronized and controlled with the master
unit. For this select the desired operating mode at the master unit and set each slave unit to 'SLAVE' mode:
press [FUNC] repeatedly until the display shows 'MODE: SLAVE' and confirm with [ENTER].
Device Settings
Press [FUNC] repeatedly until the display shows 'MODE: SETTING'. In this menu you can adjust some
features of the device. Use the [UP] and [DOWN] buttons to select the submenus available.
► Color Selection
Press [DOWN] repeatedly until the display shows 'MODE: SETTING COLOUR'. In this menu you can select
the colors to be displayed. Use the [UP] and [DOWN] buttons to select, whether the unit should only display
white color ('SINGLE COLOUR'), two colors ('DUAL COLOUR') or all colors ('MULTICOLOUR'). Press
[ENTER] to confirm and save the setting. Press [FUNC] to return to the submenu level.
► Mirror Laser Beam
Press [DOWN] repeatedly until the display shows 'MODE: SETTING MIRROR'. Press 'ENTER'. Use the [UP]
and [DOWN] buttons to choose whether and how the laser beam should be mirrored:
•
Mirroring on X- and Y-axis ('SY: Y, SX: Y')
•
Mirroring on Y-axis only ('SY: Y, SX: N')
•
Mirroring on X-axis only ('SY: N, SX: Y')
•
No mirroring ('SY: N, SX: N')
Press [ENTER] to confirm and save the setting. Press [FUNC] to return to the submenu level.
► Microphone Sensitivity
Press [DOWN] repeatedly until the display shows 'MODE: SETTING MUSIC', then press [ENTER]. This
menu is used to set the response characteristic of the built-in microphone. Use the [UP] and [DOWN] buttons
to select a value between low and high sensitivity. The bargraph in the display indicates the sensitivity. Press
[ENTER] to confirm and save the setting. Press [FUNC] to return to the submenu level.
www.eurolite.de
40
Werbung
Inhaltsverzeichnis
