Rigging Instructions - EuroLite VLS-1200RGB MICRO 30K Bedienungsanleitung

Rigging Instructions

Please consider the EN 60598-2-17and the respective national standards during the
installation! The installation must only be carried out by an authorized dealer!
Suspended installation by experienced and trained persons only. Incorrect installations are a
potential danger, especially if systems are flown above persons.
Before taking into operation for the first time, the installation has to be approved by an expert!
For installation in public or industrial areas, a series of safety instructions have to be followed that this
manual can only give in part. The operator must therefore inform himself on the current safety instructions
and consider them. The manufacturer cannot be made liable for damages caused by incorrect installations
or insufficient safety precautions!
• The device has to be installed out of the reach of people and should be installed outside areas where
persons may walk by or be seated.
• The installation of the device has to be built and constructed in a way that it can hold 10 times the weight
for 1 hour without any harming deformation.
• When rigging, derigging or servicing the device staying in the area below the installation place, on bridges,
under high working places and other endangered areas is forbidden.
• If the device shall be lowered from the ceiling or high joists, professional trussing systems have to be used.
The device must never be fixed swinging freely in the room.
• Hanging devices may cause severe injuries when crashing down! If you have doubts concerning the safety
of a possible installation, do NOT install the device!
• Overhead rigging requires extensive experience, including (but not limited to) calculating working load
limits, installation material being used, and periodic safety inspection of all installation material and the
device. If you lack these qualifications, do not attempt the installation yourself, but instead use a
professional structural rigger. Improper installation can result in bodily injury and or damage to property.
• The installation must always be secured with an appropriate secondary safety element (e.g. steel rope).
This secondary safety attachment must be constructed in a way that no part of the installation can fall down
if the main attachment fails.
You must only use safety bonds complying with DIN 56927, quick links complying with DIN 56927,
shackles complying with DIN EN 1677-1 and BGV C1 carbines. The safety bonds, quick links, shackles
and the carbines must be sufficiently dimensioned and used correctly in accordance with the latest
industrial safety regulations (e. g. BGV C1, BGI 810-3). The maximum drop distance must never exceed 20
cm. A safety bond which already held the strain of a crash or which is defective must not be used again.
• The operator has to make sure that safety-relating and machine-technical installations are approved:
- by an expert before taking into operation for the first time and after changes before taking into operation
another time.
- by an expert after every four year in the course of an acceptance test.
- by a skilled person once a year.
www.eurolite.de
DANGER TO LIFE!
DANGER TO LIFE!
DANGER TO LIFE!
35