Unpacking The Appliance; Attaching The Accessories - Kärcher SC 1122 Betriebsanleitung

The appliance is not intended for use by
young children or infirm persons without
supervision.
Young children should be supervised to
ensure that they do not play with the
appliance.
The unit must never be without supervision
while it is operating.
Cleaning of electrical appliances
When cleaning electrical appliances
(including electric cookers), they must be cut
off from the mains (switch off circuit breakers
or remove the fuse). Before returning them to
normal operation, the appliances must be
allowed to dry thoroughly.
Please observe the instructions of the
respective appliance manufacturers!
Steam cleaning is prohibited on all electrical
appliances, i.e., hair dryers, electrical
heaters, etc. that allow direct steam contact
with electrical wiring and switches. The
steam could enter into the electrical
components and, on condensing, cause an
electrical defect.
Never touch the steam jet with your hand, or
direct it at persons or animals (scalding
hazard).
Materials containing asbestos and other
items known to contain hazardous
substances must not be steam-cleaned.
Maintenance
Prior to performing
maintenance procedures, and before
replacing parts, the power plug must be
disconnected.
Repair and service procedures may only be
performed by authorised customer service
depots or by experts who are thoroughly
familiar with all applicable safety regulations.
SC 1122
When you unpack the appliance, check that
everything is complete (see page 3). If there are
any missing parts or you detect any transport
damage, please inform your dealer immediately.
Do not place the packaging into the ordinary
refuse for disposal. The packaging materials can
be recycled. Please dispose of it at an appro-
priate collection point.
• Firmly insert the accessory plug (B6) into the
• Connect the desired accessory part (C1, D1)
• If required, use the extension tubes (F1).
• To detach the accessory parts, press the
cleaning and

Unpacking the Appliance

Attaching the Accessories

socket (A6).
with the steam gun (B1).
Put the tubular end of the accessory part on the
steam gun (B1). Then, push the accessory part onto
the steam gun until the unlocking button (B3) of the
steam gun locks into place (see Figure 1).
Figure 1: Attaching accessory to the steam gun
Attach one or both extension pieces (F1) to
the steam gun (B1). Then, push the desired
accessory part (C1, D1, G1) onto the free end
of the extension tube.
unlocking button (B3 or F2), and pull the items
apart (see Figure 2).
Figure 2: Detaching the accessory parts
Hot water may drip out of the accessory parts while
you are detaching them! Never detach the
accessory parts while steam is being emitted –
dangerof scalds!
English – 17