Truma CP plus VarioHeat Gebrauchsanweisung Und Einbauanweisung Seite 29

– When air conditioning systems are being operated, use
only the time switch of the Truma CP plus VarioHeat
control panel to clearly define the start and end time for
a required period.
– If the time switch has been activated (ON), the deacti-
vate time switch menu is displayed first (OFF).
– Select icon in menu bar (4) with rotary push button.
– Change to the setting level by tapping on the rotary push
button.
Entering the start time
– Set the hours then the minutes with the rotary push button.
24 h mode
Fig. 11
12 h mode
= a. m.
= p. m.
Fig. 12
Entering the end time
– Set the hours then the minutes with the rotary push button.
24 h mode
Fig. 13
If the start/end point was exceeded during entry, the op-
erating parameters are not taken into consideration until
the next start/end point has been reached. Until then, the op-
erating parameters that have been set outside the time switch
remain valid.
Setting the room temperature
– Depending on the appliance that is connected, use the rotary
push button to select heating system (HEATER), or air condi-
tioning system (AC) or automatic climate control ( AUTO) (see
"Changing the room temperature" on page 26).
– Tap rotary push button to confirm selection.
– Select required room temperature with rotary push button.
– Tap the rotary push button to confirm the value.
Fig. 15
12 h mode
= a. m.
= p. m.
Fig. 14
29