Set Time Switch - Truma CP plus VarioHeat Gebrauchsanweisung Und Einbauanweisung

Heater (HEATER)
Icon Operating
mode
– OFF
a VENT
1
b AUTO
c BOOST2
d NIGHT
Can cause increased motor wear, depending on how often it is
1.
used. Quick level change possible using the rotary push button (in
stand-by screen).
Fan level "BOOST" results in higher power consumption, higher
2.
noise level and increased motor wear.
As soon as the heater is switched on (room temperature
selected), the status bar (2) displays the fan level that
was selected during the previous heating cycle. The default
setting is "AUTO".
28
Description
Fan is switched off.
(only selectable if no appliance
is in operation).
Air circulation if no unit is in oper-
ation. 10 speed settings available.
Automatic control of the fan, de-
pending on the heating power /
optimised to the current heating
requirement
Rapid room heating
Available if the difference be-
tween the selected and actual
room temperature is >10 °C
Not available in electrical mode
(EL1, EL2).
Ultra-quiet fan operation. Heat-
er running only at partial load.
Might not be possible to reach
the set room temperature (de-
pending on the vehicle size and
outside temperature). Available
only in gas mode (GAS).
Air conditioning system (AC)
Icon Operating
mode
– OFF
a –
b LOW
c MID
d HIGH
e NIGHT
f AUTO

Set time switch

Danger of toxic exhaust fumes.
The activated time switch switches on the heater even
when the vehicle is parked. The heater's exhaust can be tox-
ic in enclosed spaces (e.g. garages, workshops).
If the vehicle is parked in closed rooms:
– Shut off the (gas) fuel supply to the heater.
– Switch off the Truma CP plus VarioHeat control panel
to prevent the heater being switched back on by the
Truma App or the time switch (see "Switching on/off").
Description
Fan is switched off
(only selectable if no appliance
is in operation).
–
Low fan level
Medium fan level
High fan level
Ultra-quiet fan operation
Automatic fan level selec-
tion. Cannot be changed in
AUTO mode.