Operation; Before First Use; Connection; Disconnecting - ULTIMATE SPEED ULG 3.8 B1 Bedienungsanleitung

RISK OF CHEMICAL BURNS!
Wear safety goggles! Wear
■
protective gloves! If your eyes or
skin come into contact with battery
acid, rinse the affected part of the
body with plenty of clear running
water and seek immediate medical
assistance!
GB
Avoid an electric short-circuit when
■
MT
connecting the charger to the bat-
tery. Connect the negative terminal
connecting cable to the negative ter-
minal of the battery or to the vehicle
bodywork/earth only. Connect the
positive terminal connecting cable
only to the positive terminal of the
battery!
Do not set up the charger near a
■
fire or subject it to heat or to long-
term temperatures exceeding 50°C!
When attaching the charger, be
■
sure not to damage any lines for
fuel, electricity, braking system,
hydraulics or water with screws!
Do not cover the charger with objects
■
of any kind!
Protect the electrical contacts of the
■
battery against short-circuiting!
Use the charger exclusively for
■
charging or trickle charging undam-
aged 6 V/12 V lead batteries! Fro-
zen batteries may not be charged.
28

Operation

Before first use
♦ Before connecting the battery charger, read the
operating instructions of the battery thoroughly.
♦ In addition, observe the vehicle manufacturer's
instructions for a permanently connected bat-
tery. Secure the vehicle; turn off the ignition.
♦ Clean the battery terminals. Ensure that no dirt
comes into contact with your eyes in the process.
♦ Provide for sufficient ventilation.

Connection

NOTE
► There are two options for connecting the charger.
Connect the negative terminal connecting cable
(black) either directly to the negative terminal of
the battery or to the bodywork. Please also bear
in mind the vehicle manufacturer's instructions.
♦ Before starting the charging or trickle charging
procedure on a permanently installed battery in
a vehicle, first disconnect the negative terminal
connecting cable (black) of the vehicle from the
negative terminal of the battery. The negative
terminal of the battery is usually connected to
the vehicle's bodywork/earth.
♦ Then disconnect the positive terminal connect-
ing cable (red) of the vehicle from the positive
terminal of the battery.
♦ Clamp the positive terminal clamp (red)
charger to the positive terminal on the battery.
♦ Clamp the negative terminal clamp (black)
the charger to the negative terminal on the battery
or to the bodywork.
♦ Connect the mains cable
charger to the power socket.
♦ If the terminal clamps are connected incorrectly,
the LED display "ERROR"

Disconnecting

♦ Disconnect the appliance from the power supply.
♦ Remove the negative terminal clamp (black)
of the charger from the negative terminal on the
battery or from the bodywork.
of the
of
of the battery
will light up.
ULG 3.8 B1