VOLTCRAFT SPEED EX15 Pro Bedienungsanleitung Seite 24

- The slow charge process starts and the green indicator blinks.
- Press the MODE button (9) twice. The charger confirms your entry with 2 beeps and
switches to discharge mode. This is signaled by the blue indicator (6).
- The discharge process can be interrupted at any time by pressing the button
„MODE" (9).
- By selecting the display „Capacity", you can check the discharged capacity.
- Once the final discharge current is reached, the charger automatically switches to
trickle charge mode and after approx. 2 min. to quick charge mode. When the
accumulator is fully charged, the charger switches to trickle charge and signals the
end of the charging process with a double beep. Now you can remove the accu-
mulator.
Three discharge/charge cycles are used for damaged accumulators. The accumula-
tor is discharged and recharged three times in sequence. These cycles regenerate
many accumulators and restore their full capacity.
Proceed as follows:
- Select the accumulator type as described in the chapter „Commissioning - Accu-
mulator connection" and connect the accumulator.
Observe the proper selection of the charge current.
- The slow charge process starts and the green indicator blinks.
- Press the MODE button (9) four times. The charger confirms your entry with 4
beeps and switches to discharge mode. This is signaled by the blue indicator (6).
- The discharge process can be interrupted at any time by pressing the button
„MODE" (9).
- By selecting the display „Capacity", you can check the discharged capacity.
- Once the final discharge current is reached, the charger automatically switches to
trickle charge mode and after approx. 2 min. to quick charge mode. Two additional
discharge/charge cycles follow when the accumulator is charged.
- After 3 cycles, the charger automatically switches to trickle charge and signals the
end of the charging process with a double beep. Now you can remove the accu-
mulator.
24