Assembly - Cleanmaxx GW906-S60 Gebrauchsanleitung

EN

Assembly

PLEASE NOTE!
■ Before attaching or removing the accessories, make sure that the device is not at-
tached to the mains supply.
Inserting/removing the dust bin
Mounting/removing attachments
During assembly, the attachments are connected and pulled out when disassembled.
1. Adapter 1 (3) must always be inserted in the suction opening (I) fi rst, that is, with
the wider end. It must not be loose!
2. Choose one of the following attachments and connect it to adapter 1 (3):
– large crevice nozzle (4),
– large brush nozzle (5),
– extension suction tubes,
– adapter 2 (6) for the small attachments.
3a. The following attachments can be connected to the extension suction tubes:
– fl oor nozzle (13):
– large crevice nozzle (4) and
– large brush nozzle (5).
3b. The following parts are attached to adapter 2 (6):
– all small nozzles,
– the angle piece (7) or
– the extension tubes (8).
20
• Removal: Push the release button (A) for the dust bin. The
dust bin (1) disconnects from the motor unit (2) and can be
removed.
• Insertion: Place the dust bin (1) on the catch located in the
bottom area of the motor unit (2). Then push the dust bin (1)
against the motor unit (2) until both parts lock into place and
are securely connected.