Cleanmaxx GW906-S60 Gebrauchsanleitung Seite 22

EN
Cleaning the fi lters
1. Empty the dust bin (1) (see above).
7. Assemble the parts as follows once they are clean and dry:
a) Put the cyclone insert (H) back in the dust bin (1). Make sure that the three catches
on the edge of the cyclone insert (H) are fi tted into the corresponding recesses in
the dust bin. They have different sizes.
b) Insert the foam fi lter (L) in the fi lter holder (K) and place it on the cyclone insert (H).
c) Place the lid (J) on the dust bin (1) so that the marking line on the edge of the lid is
located next to the
d) Turn the lid clockwise up to the stop point towards the
e) Place the dust bin (1) on the catch located in the bottom area of the motor unit (2).
Then push the dust bin (1) against the motor unit (2) until both parts lock into place
and are securely connected.
Cleaning the motor unit and attachments
• If necessary, wipe the motor unit (2) and the attachments off with a soft, damp cloth.
Dry with a soft cloth.
• Regularly remove hair and lint from the nozzles.
Storage
Store the device in a cool, dry place not exposed to direct sunlight and out of the reach
of children and animals.
2. Turn the lid of the dust bin (J) slightly anticlockwise and
then lift it off.
J
3. Take the fi lter holder (K) off of the cyclone insert (H).
K
K
H
5. Carefully take the cyclone insert (H) out of the dust bin (1).
6. Knock all parts out over a rubbish bin and brush them off
1
if necessary. Rinse all parts except the fi lters off with clean
water if necessary. ATTENTION: Do not use any deter-
gent!
Then let them dry completely. Do not assemble when
wet or damp!
symbol on the dust bin (1).
22
4. Pull the foam fi lter (L) out of the fi lter
L
holder (K). The fl eece fi lter is secure-
ly attached to the fi lter holder (K)
and cannot be removed!
symbol.