Changing The Fuse; Tips And Notices - MC Crypt DM-19 Bedienungsanleitung

11. Changing the Fuse

Pull the power plug out of the non-heating equipment connection socket.
Remedy the cause for the blown fuse (e.g. overload of the outputs, short circuit on the inputs/outputs).
Now remove the fuse holder from underneath the non-heating equipment connection socket with a suitable tool, e.g.
a screwdriver.
Replace the defect fuse (250V, 0.5AT, slow-blow) with a new one of the same type.
Never bridge or repair a defect fuse!
Mortal danger and danger of fire through overload! This also destroys the mixing desk.
Replace the fuse holder with the new fuse in the correct direction and re-connect the mixing desk with the mains
voltage.

12. Tips and Notices

Pin assignment XLR (symmetrical operation, mono)
Pin 1: Ground (GND)
Pin 2: Plus (+, HOT)
Pin 3: Negative (-, COLD)
Pin assignment jack plugs (symmetrical operation, mono)
1 Ground (GND)
2 Plus (+, HOT)
3 Negative (-, COLD)
Please do not mix up the assignment with common stereo jack plug connections (left/right/ground), for
example for headphones!
When changing from symmetrical to unsymmetrical operation, (1) and (3) must be bridged. Asymmetrical
XLR connections may not be used to connect microphones. A possible phantom feed will then be short-
circuited.
2
2 3 1
3 1
35