JVC EXAD KW-AVX800 Bedienungsanleitung Seite 64

Equalizer
Flat/Hard Rock/R&B/Pop/Jazz/Dance/Country/Reggae/Classic/User1/User2/User3, [55]
Sound
Menu items
Fader/Balance
Volume Adjust
Subwoofer Phase
18
Subwoofer Level*
High Pass Filter
Crossover
Amplifier Gain
Rear Speaker * 19
* 18
This subwoofer level setting takes effect only when surround is deactivated. ( also page 27)
* 19
This setting takes effect only when Dual Zone is activated. ( also page 30)
Selectable settings, [reference page]
Adjust fader—speaker output balance between the front and rear speakers.
• Upmost—front only (F6)
• Downmost—rear only (R6)
When using a two-speaker system, set the fader to the center (0).
Adjust balance—speaker output balance between the left and right speakers.
• Leftmost—left only (L6)
• Rightmost—right only (R6)
Adjust and store auto-adjustment volume level for each source, comparing to
the FM volume level. The volume level will automatically increase or decrease
when you change the source.
–12 to +12; Initial 00
• For Disc/SD/USB: An auto-adjustment level is commonly used when playing
DivX/MPEG1/MPEG2/MP3/WMA/WAV/AAC files
Select either <Normal> or <Reverse>, which reproduces a better sound.
Adjust the subwoofer output level. Level: –06 to +08; Initial 00
Through: Select when the subwoofer is not connected.
On: Select when the subwoofer is connected.
Adjust the crossover frequency between the front/rear speakers and the
subwoofer.
80Hz, 120Hz, 150Hz
You can change the maximum volume level of this unit.
Off: Deactivates the built-in amplifier.
Low: VOL 00 to 30 (Select this if the maximum power of the speakers is less
than 50 W)
High: VOL 00 to 50
You can activate/deactivate the rear speakers.
Off, On
64