9.5
Checking the safety elements
Check that safety elements and protective grilles are securely fastened.
9.6
Checking the connections
Switch the fan off.
WARNING
Danger from electrical voltage!
»
Ensure that all phases are completely free of voltage.
»
Observe the 5 rules of electrical safety (see section 2.5)!
Check that the connection cables are fi tted properly
Lay the connection cables in the terminal box in such a way that allows the cover of the terminal box to be closed without resis-
tance.
Use all of the locking screws.
Insert the screws by hand to avoid damaging the thread.
9.7
Switching the device on
Before switching the device on, check the device for damage and ensure that the protective equipment functions properly.
Check the airways of the fan for foreign bodies and remove any found.
Apply the nominal voltage for supply.
Start the device by altering the input signal.
9.8
Switching the device off
9.8.1
Switching the device off during operation
Switch off the device via the control input.
Do not switch the motor (e.g. in cycle operation) on or off via the mains.
9.8.2
Switching the device off for maintenance work
WARNING
Danger from electrical voltage!
»
Observe the 5 rules of electrical safety (see section 2.5)!
Switch off the device via the control input.
Do not switch the motor (e.g. in cycle operation) on or off via the mains.
Disconnect the device from the power supply.
When disconnecting, make sure to remove the earth wire last!
46
Commissioning